Once the hangers have been installed, the set of lines can now be placed. Usually, an installer starts with the suction line and extends one end a few meters, leaving the rest of the roll in a coil. They then push the unrolled section through a hole drilled through the house's bandboard to the outside, near the air conditioner. A sufficient portion of the line is pushed to reach the air conditioner service valve.
Your air conditioner unit can be installed on the floor in a convenient location or on the ceiling. The chosen location must have good airflow, be easily accessible for repair and general maintenance, and be far enough away from social areas so that noise is not a problem. If you decide to place it on the ground, you will first need to lay a concrete slab. Basically, evaporator coils use refrigerant to remove hot air and moisture from inside the house and send them through the ducts to the outdoor condenser.
In most cases, the current location of the air conditioner will require some preparation work before the new air conditioner can be installed. One of these is you need to check if there's any water leak from the ceiling or walls caused by the gutter outside. A clogged gutter may not properly drain water, which can lead to water damage to your ceiling or interior walls. In cases like this, it may be a good idea to contact a professional gutter cleaning service like Gutter Cleaning Dayton OH They can help you determine the extent of the damage and help you avoid further damage. This type of repair can be expensive, but it's well worth it. They can also advise you on how to maintain your gutters to ensure that they don't overflow.
Next, the set of pipes that was installed in the previous step is formed and mounted on the corresponding service valve of the new air conditioner. However, if the coil is installed according to the manufacturer's code and specifications in the existing duct system, can drain properly and is sealed to prevent air leaks, you'll enjoy the same level of comfort. A good HVAC contractor will have trained installation teams that will properly start your air conditioner before leaving work.
Not only will you have to pay for work time, but there may also be a number of preparation tasks that increase the cost of installing your air conditioning system. If you don't have previous air conditioning installation experience, it's probably worth hiring professionals to install your central air conditioning system. The most worrying fact is that there are many HVAC companies and air conditioning installers who don't know all the steps that must be part of a good installation. In older air conditioning systems, the oil in the existing piping set is different from the oil found in the new air conditioner.
A central air installation can be a significant four- or even five-figure investment, and not everyone has thousands of dollars at their disposal. Installing the system yourself may also void the warranty, as most require the units to be installed by authorized technicians. All refrigeration contractors should begin the evaluation of their home by performing a load calculation from the Air Conditioning Contractors of America Manual J. Air conditioning systems with higher SEER ratings work more efficiently, but are often more expensive to install.
The low voltage control cable is connected directly to the air conditioner condenser in the appropriate locations according to the air conditioning condenser installation instructions. Learn how installation procedures dramatically affect the life and efficiency of your air conditioner.
